Rode NT4
A stereo mic with two matched capsules that captures natural, spacious sound from a single unit.
Tällä ostoksella pääset klubijäseneksi ilmaiseksi
Lue lisää- Klubihinnat kaikille tuotteille
- Ilmainen pakettiautomaattitoimitus alkaen 150 €
- Voimassa 3 vuotta, jokainen ostos pidentää
- Kuukausittaiset jäsentarjoukset
4.8
866 arvostelua
GPS Eesti Googlessa
- X/Y stereo condenser microphone
- Matched 1/2" capsules with gold-sputtered diaphragms
- Precisely matched capsules with full-frequency sensitivity
- Dual powering
- Custom stereo cables included - 5-pin stereo XLR, Minijack (via included cable) and dual 3-pin XLR (via included cable)
- Includes custom dual-head windshields (WS4), RC4 case and 5-pin Minijack and XLR stereo cables
- Surface-mount circuitry
The RØDE NT4 stereo microphone has a perfect X/Y stereo configuration that can be used without complicated stereo setups or matched microphone pairs. Simply place the microphone where you need it and record realistic stereo sound with just one microphone.
Acoustically matched 1/2" cardioid condenser capsules are mounted at 90 degrees, producing a stereo image suited to drums, choirs, spoken word and sound design both in and out of the studio.
Dual powering adds to the NT4's versatility: the microphone runs on either a 9V battery or 48V phantom power. Both XLR and 3.5mm minijack cables are included, so the NT4 can be connected to a mixing desk, recorder or camera.
The RØDE NT4 is designed and made in Australia
| Transducer | 2 externally polarised condensers in stereo 'XY' configuration |
| Polar Pattern | Stereo (each capsule is cardioid) |
| Frequency Response | 20Hz - 20kHz |
| Dynamic Range (typical) | > 128dB |
| Signal-to-Noise Ratio | 78dB |
| Maximum Input Sound Level | 143dB (@ 1% THD into 1k) |
| Power Requirements | 4mA, P48 (38v-52v) 2mA, P24 (20v-26v) 2.8mA, P12 (10.8v-13.2v) or 2.4mA using a 9v battery |
| Output Impedance | 200 Ohms |
| Output Connections | XLR-5M type [5-pin stereo XLR, Minijack (via included cable) and dual 3-pin XLR] |
| Pad | No |
| Low Frequency Cut-off | No |
| Dimensions | 9.28 x 1.28" (232 x 32mm) |
| Weight | 16.9 oz. (480g) |
- NT4 - X/Y stereo condenser microphone
- RM3 - Durable microphone clip
- RC4 - Durable microphone case
- WS4 - Pop filter/windshield
- 5-pin to stereo minijack cable
- 5-pin to dual XLR cable
